Automatic Curtain Motor instructions
IO SummaryÂ
Â
1. Side Switch L |
4. Status LED |
2. PROG button |
5. Side Switch R |
3. USB-C charging port |
LED states
LED behaviour | Meaning |
Solid green |
Motor is in RF pairing mode |
Solid amber |
Motor is currently charging |
Green blink x2 |
Command received |
Green blink x3 |
Wake up from deep sleep mode |
Amber blink x3 |
Enter deep sleep mode |
Red blink in motion |
Battery low / limits not set |
Red blink x2 |
An error has occurred |
Deep Sleep Mode     Â
The motor has a deep sleep mode to minimise battery consumption and prevent accidental activation during transportation or storage. Motors are always shipped with deep sleep mode activated.
Wake up from deep sleep mode
When motor is in deep sleep mode, hold down the PROG button until the status LED blinks green 3 times. Motor is now in active mode.
Enter deep sleep mode
When motor is in active mode, hold down the PROG but- ton until the status LED blinks amber 3 times. Motor is now in deep sleep mode.
Battery Charging            Â
The charging port on the motor accepts any standard USB Type C charging cable. To charge the motor, simply plug a USB Type C charging cable into the charging port and plug the other end of the cable into a USB charging device such as a phone charger or a power bank. Typically, a full charge takes up to 8 hours. Built-in safety circuity ensures that the battery cannot be over-charged.
When the motor is charging, the status LED will light up as solid amber. Once fully charged, the LED will switch off.
Using the Onboard Controls       Â
Limit setting
- Manually position the motor to the fully closed posi- tion on the track and clamp on (please see Installa- tion Instructions for more details on how to do this).
- Press and hold both Side Switch L and Side Switch
- After 3 seconds, the motor will jog indicating it has entered limit setting mode.
- Using either Side Switch L or Side Switch R, tap the one that is facing the fully open position.
- The motor will run towards the fully open position until it detects that it has reached the end.
- Limit setting is now
Normal operation
Pressing either side switch L or side switch R will send the motor in the same direction as the direction of the push. The motor will continue running until either a) it reaches the end limit or b) the opposing side switch is pressed.